INSTRUCTIONS FOR USE
Congratulations! You are about to enjoy the wonderful immediate and cumulative, visible results of microcurrent for facial lifting, toning and contouring.
In the NuFACE® kit, you will find the following products in addition to your NuFACE® hand-held, battery operated device:
NuFACE® Derma-Gel Conductivity Solution
Use Derma-Gel in conjunction with the NuFACE® device to lift and tone the face. In order for the device to function properly, the Derma-Gel must be used.
If the Derma-Gel begins to dry during your NuFACE® treatment, reactivate the gel by spraying the Optimizing Mist to the area being treated.
NuFACE® Optimizing Mist Post Solution
Firms and hydrates the skin. Use the Optimizing Mist following your NuFACE® application to finish and optimize the treatment.
Please take the time to watch our NuFACE instructional DVD:
HOW TO USE YOUR NUFACE MICROCURRENT DEVICE
STEP 1: Cleanse Your Face & Apply the Derma Gel to the Area to be treated.
Start by cleaning your face with a non-oil based cleanser.
Skin Health Tip: Exfoliate the areas to be treated 1-2 times a week for enhanced results.
(Men should shave before use as hair can interfer with the conductivity of the probes. Facial areas under a beard or mustache cannot be treated.)
When using NuFACE® make sure you are positioned in front of a mirror in a well-lit room.
For your NuFace® device to operate properly, a conductive solution is needed. Therefore, it is important to first apply the Derma-Gel to the skin areas to be treated. Ensure the entire area being treated is saturated with the conductive Derma-Gel.
STEP 2: Turn On NuFACE®, touch the two spheres to the skin & glide upwards (see photos below) for 5 seconds.
Turn your NuFACE® unit on by pushing the on/off thumbwheel on left side of machine all the way up. The Green LED will illuminate, indicating the unit is on and ready for use. Begin your NuFACE® treatment as described in this usage manual.
You may adjust the intensity level (microcurrent level output) to your comfort by turning the thumbwheel intensity selector-located at the left side of machine-up or down. Always keep both probes on the skin at the same time as the device will automatically switch polarity during treatment.
Following the natural contours of your face, simply glide the NuFACE® over your skin for an instant visible lift. Repeat until the entire facial area has been treated, avoiding eye area and around the mouth.
REPEAT EACH STEP A TOTAL OF THREE (3) TIMES. GLIDE NuFACE® VERY SLOWLY.
Spray Optimizing Mist over Derma-Gel if gel begins to dry during your NuFACE® treatment.
STEP 3: Rinse, firm & hydrate.
Remove Derma-Gel with warm damp washcloth. Spray Optimizing Mist and apply your preferred moisturizers.
Remember to turn your NuFACE® device off after every treatment.
Upon the completion of your NuFACE® treatment, apply the Optimizing Mist to promote continual firming and hydrating. Regular use of your NuFACE® device will provide you with increasing facial strength and tone, while maintaining a more vibrant appearance.
Using your NuFACE® for just 5 minutes a day will deliver instant facial rejuvenation results.
INDICATIONS FOR USE and INTENDED USE
The NuFace® Facial Toning Device is intended for facial stimulation and is indicated for over-the-counter cosmetic use only.
WARNING: Areas To Avoid:
DO NOT USE NUFACE® ON:
• Mid line of neck (bone of neck)
• Mouth Area (circular muscle inside nasolabial fold)
• Eye area (circular muscle inside orbital rim)
To clean your NuFACE® device, wipe the unit with a damp cloth.
Do not submerge the unit in water or any other liquid.
CONTRAINDICATION FOR USE
NuFACE® should not be used in the following areas:
• Around the mouth (Orbicularis Oris)
• Eye areas (Orbicularis Oculi Muscle)
• Mid-line facial and throat area (vertical center)
NuFACE® should not be used by:
• Pregnant Women
• People subject to seizures
• People with cancer/tumors
• People with cardiac pacemaker
• People with electronic implanted devices
• People with implanted defibrillators/stimulators
This device is solely intended for cosmetic use on the face. Any harmful consequence resulting from misuse or application to other body areas, connection to improper voltage sources, dirty conductive solution or probes, or any other improper applications is neither the responsibility of Carol Cole Company nor its